A serious sim rig can have:
- Wheelbase + pedals + shifter/handbrake
- PC + monitors (or triples)
- USB hubs
- Tactile amps
- Fans / wind sim
- Lighting / streaming gear
That’s a lot of power bricks — and a lot of ways to build a fragile setup.
Safety note: This is general guidance. If you’re unsure about electrical safety, use reputable power equipment and consult a qualified professional.
What “good power management” looks like
- One main power area (power strip/surge protector mounted securely)
- Strain relief so cables can’t tug plugs loose
- Clear cable routing away from pedals and moving parts
- Labeling so you can troubleshoot quickly
Surge protection and power strips
- Use a quality surge protector for PC/monitors.
- Avoid daisy-chaining multiple power strips.
- Don’t overload a single outlet with high-power devices.
Separate power and signal when you can
Some rigs get audio noise or USB instability when power and USB cables are bundled together. You don’t need perfection — just avoid tight, messy bundles.
Mount it like it matters
Power bricks hanging in the air create stress on cables and connectors. Secure them to the rig where possible.
Share:
Pit stop practice: Entry, speed limiter and not losing 10 seconds
Quieting a rig with tactile: Isolation feet, mats and volume control